Revision notesIntermediate · Section 6: Electromagnetic compatibility

Station layout, RF earths and mobile installations

Connecting the station to minimise EMC problems, what a good RF earth is, where not to put a transmitting antenna, and installing a radio safely in a vehicle.

Key points

InterconnectionShort screened leads; transmitter → SWR meter → low pass filter → feeder → antenna.
Good RF earthShort, thick conductor or braid to earth rods or radials outside; low impedance at RF. Follow RSGB guidance for PME homes.
PurposeReturn path for RF, keeping it off the mains earth; fewer EMC problems.
Antenna sitingAway from mains wiring and TV/radio antennas and downleads; loft and indoor antennas worsen EMC.
VehiclesDon't run leads along the wiring loom or near ECUs; ≥ 10 W can upset vehicle electronics.
Mobile antennaRoof mounting gives lower exposure inside than wing or boot mounting.

Covered in the full lesson

  • Cables
  • Order
  • RF earth
  • Antenna
  • Vehicle

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

Where should the low pass filter go in a station?
  1. Last in line before the feeder to the antenna
  2. Between the microphone and the transmitter
  3. In the mains lead feeding the power supply
  4. Before the power supply, on its input leads
Answer: A. Last in the chain, so it filters everything before it.

The full lesson adds more

In the Intermediate course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Previous: EMC: immunity, how interference gets in, and the cures

All revision notes · Free video lessons · The three exams