Revision notesIntermediate · Section 6: Electromagnetic compatibility
EMC: immunity, how interference gets in, and the cures
What electromagnetic compatibility means, how amateur signals and household devices interfere, direct pick-up and broadband amplifiers, and the cures: filters, ferrites, common-mode chokes and the dummy load test.
Key points
EMC principleEquipment should work in its environment without disturbing other equipment. All electronics can radiate and absorb RF.
ImmunityImproved by screening and filtering power, signal and control leads. New kit meets BSI standards; old or badly installed kit may not.
SymptomsAM/SSB: speech-like sounds. FM: muting or lost volume. Digital TV: freezing, pixelation. DAB: loss of signal.
Household sourcesThermostats, ignition, motors, computers, SMPSUs, plasma TVs, VDSL, LED lighting, solar PV inverters.
RoutesDirect pick-up (esp. VHF/UHF); broadband TV amplifiers overloading.
Common and differential modeCommon mode flows the same way on both conductors or the braid; a ferrite choke attenuates it.
Cures and testsSupply-lead and mains filters, ferrite rings, high/low pass filters. General coverage receiver for spurious emissions. Dummy load: radiated or conducted?
Covered in the full lesson
- RF entering the mains
- Pick-up on a TV downlead
- Braid (common mode) currents
- Broadband masthead amplifier
- Is it radiated?
Quick check
An exam-style question on this lesson. Open it to see the answer and why.
What is the likely effect of an SSB transmission on a nearby audio system?
- Speech-like sounds
- The picture freezes
- Silence only
- A steady whistle at 1 kHz
Answer: A. AM and SSB tend to produce speech-like sounds; FM tends to mute.
The full lesson adds more
In the Intermediate course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.