Revision notesFull · Section 9: Measurements and construction

Test equipment: meters, SWR bridges, oscilloscopes and spectrum analysers

Multipliers and shunts, how meters load circuits, source and load impedance, how SWR meters work, reading an oscilloscope, and what a spectrum analyser shows.

Key points

MetersVoltmeter: series multiplier. Ammeter: parallel shunt. A meter loads the circuit and can change the reading.
Source impedanceSignal generators are usually 50 Ω; the level depends on the load (open circuit ≈ twice the 50 Ω level). Not all instruments have 50 Ω inputs.
SWR metersSense wire in a coaxial line, or a current transformer with a capacitive voltage tap. Single meter with a switch, twin meters or cross-needle.
OscilloscopePeriod = divisions × time/div; f = 1 ÷ period. Voltage (peak-to-peak) = divisions × volts/div.
Spectrum analyserAmplitude against frequency. Fundamental, harmonics and spurious products.

Covered in the full lesson

  • Voltmeter
  • Ammeter
  • Signal generator
  • SWR meter
  • Oscilloscope
  • Spectrum analyser

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

A 1 mA, 100 Ω meter is to read 10 V full scale. What multiplier is needed?
  1. 9.9 kΩ
  2. 10 kΩ
  3. 100 kΩ
  4. 99 Ω
Answer: A. Total 10 V ÷ 1 mA = 10 kΩ, minus the meter's 100 Ω.

Can you work it out?

A 1 mA, 100 Ω meter is to read 10 V full scale. Find the multiplier.

The full lesson walks through the working step by step, with 3 worked examples in all.

The full lesson adds more

In the Full course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Next: Measuring power and frequency, decibels and temperature effects

All revision notes · Free video lessons · The three exams