Revision notesFull · Section 3: Transmitters and receivers

SDR, I and Q, transceivers and transverters

Phasors, I and Q signals and how SDR demodulates any mode, direct sampling, what transceivers share, RIT, and using transverters safely.

Key points

PhasorsLength = amplitude, angle = phase. Two axes at right angles, I (in phase) and Q (quadrature), capture all the information.
I and QMixing with two LOs 90° apart gives I and Q; once digitised, any mode can be demodulated mathematically. The reverse creates complex modulation.
Direct samplingDigitise the RF directly and extract I and Q mathematically.
TransceiversShared oscillators, common IF filters, changeover circuits. RIT shifts receive only.
TransvertersLO = band − IF (e.g. 116 MHz for 144 MHz with a 28 MHz IF). Low drive; watch band edges; correct sequencing; RF or PTT switching.
Hot switchingSwitching relays while RF is present; prevented by sequencing.

Covered in the full lesson

  • Phasor
  • I and Q
  • Direct sampling
  • Transceiver
  • Transverter

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

On a phasor diagram, what does the length of the phasor show?
  1. Amplitude
  2. Frequency
  3. Phase
  4. Time
Answer: A. The angle shows the phase.

Can you work it out?

A 2 m transverter has a 116 MHz LO. What dial frequency gives 144.300 MHz?

The full lesson walks through the working step by step, with 2 worked examples in all.

The full lesson adds more

In the Full course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Previous: Receiver performance: dynamic range, preamps, phase noise, demodulators and AGC

All revision notes · Free video lessons · The three exams