Revision notesFull · Section 3: Transmitters and receivers

Receiver performance: dynamic range, preamps, phase noise, demodulators and AGC

How overload creates intermodulation, dynamic range, phase noise, when a preamplifier helps, how AM, CW, SSB and FM demodulators work, and AGC attack and decay.

Key points

OverloadStrong signals drive stages non-linear; intermodulation products near the wanted signal mask weak ones.
Dynamic rangeMinimum discernible signal to maximum signal without overload, in dB.
Phase noiseNoise sidebands on the LO; causes reciprocal mixing. Measured in dBc/Hz at an offset; lower is better.
PreampsAt HF they rarely help and reduce dynamic range, by up to their gain. At VHF and above a low-noise preamp helps; mount it at the antenna.
DemodulatorsAM: diode envelope detector. CW/SSB: product detector with BFO/carrier insertion oscillator. FM: limiter, then discriminator.
AGCFrom the rectified IF signal. Attack and decay adjustable; fast attack, slow decay for SSB.

Covered in the full lesson

  • Overload
  • Dynamic range
  • Phase noise
  • Preamps
  • Demodulators
  • AGC

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

What is the dynamic range of a receiver?
  1. From the weakest detectable to the strongest without overload
  2. The whole range of frequencies it can tune, from lowest to highest
  3. The gain of its RF amplifier
  4. The width of its IF filter
Answer: A. Expressed in dB.

The full lesson adds more

In the Full course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Previous: The superhet in depth: mixers, image frequency and IF stages · Next: SDR, I and Q, transceivers and transverters

All revision notes · Free video lessons · The three exams