Revision notesFull · Section 3: Transmitters and receivers

RF power amplifiers: linearity, classes, peak power and ALC

Which modes need linear amplifiers, how distortion creates harmonics and intermodulation, the parts of a PA, rating for different modes, and ALC.

Key points

Linear amplificationOutput a scaled copy of the input. Needed for SSB, AM and varying-envelope data; not for FM or CW.
HarmonicsDistortion of one frequency: 2f, 3f … far from the signal; removed by a low pass filter.
IntermodulationDistortion of two or more frequencies. Third-order products 2f1 − f2 and 2f2 − f1 fall beside the signal; filters can't remove them.
PA partsInput circuit, bias, collector load (tuned circuit or RF choke), output filter and matching.
RatingsSSB speech: high peak-to-average. FM, CW, data: near-continuous; derate. Speech processing raises average power.
ALCReduces drive before overload; external PA ALC feeds back to the exciter. Manual RF power control sets output.

Covered in the full lesson

  • Linear needed
  • Class C fine
  • Harmonics
  • 3rd-order IMD
  • Duty cycle
  • ALC

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

Which mode needs a linear power amplifier?
  1. SSB
  2. FM
  3. CW
  4. FSK with constant envelope
Answer: A. Its amplitude varies with the speech.

Can you work it out?

Tones at 14.200 and 14.202 MHz. Find the third-order products.

The full lesson walks through the working step by step, with 2 worked examples in all.

The full lesson adds more

In the Full course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Previous: Oscillators and synthesisers: drift, PLL and DDS · Next: Unwanted emissions: over-modulation, harmonics, intermodulation and parasitics

All revision notes · Free video lessons · The three exams