Revision notesFull · Section 2: Technical aspects

Power supplies: stabilisers, PIV and switch mode

Stabilising circuits with Zener diodes, pass transistors and ICs, the peak inverse voltage rectifiers must survive, and how a switch mode supply works.

Key points

Zener shunt stabiliserSeries resistor and Zener across the load; low current only.
Pass transistorZener sets the base; the transistor carries the load; output ≈ Vz − 0.6 V.
IC regulatorReference, error amplifier and pass device in one, often with current limiting and thermal protection.
PIVHalf-wave with reservoir: 2 × Vpeak. Bridge: Vpeak per diode. Centre-tapped full-wave: 2 × Vpeak of each half. Allow a margin.
Switch modeRectify mains → switch at high frequency → small transformer → rectify and smooth → feedback controls switching.
Trade-offLinear: heavy, hot, quiet. Switch mode: small, efficient, can radiate RF noise.

Covered in the full lesson

  • Half-wave with reservoir
  • Centre-tapped full-wave
  • Bridge

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

In a Zener and pass transistor stabiliser, what carries the load current?
  1. The pass transistor
  2. The Zener diode
  3. The series resistor
  4. The reservoir capacitor
Answer: A. The Zener only sets the base voltage.

Can you work it out?

A half-wave rectifier with reservoir runs from 12 V RMS. Find the PIV.

The full lesson walks through the working step by step, with 3 worked examples in all.

The full lesson adds more

In the Full course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Previous: Semiconductors: Zener diodes, biasing, amplifier types and oscillators

All revision notes · Free video lessons · The three exams