Revision notesFoundation · Section 3: Transmitters and receivers

Transmitters: modulation and the transmitter block diagram

How a transmitter puts information onto a radio carrier, AM, FM, SSB and CW, the stages of a simple transmitter, and how to avoid causing interference.

Key points

ModulationAdding information to an RF carrier, in the modulator stage. Vary amplitude (AM) or frequency (FM).
SidebandsAM: carrier plus two sidebands. SSB: one sideband only.
DataSent by modulating the carrier with audio tones, often from a computer sound card.
WaveformsAM: height varies. FM: spacing varies. CW: carrier on and off.
Transmitter orderMicrophone → audio amplifier → modulator (fed by the frequency generator) → RF power amplifier → feeder and antenna.
Clean signalsWrong oscillator setting: out of band. Over-modulation or excess deviation: interference to adjacent channels. The PA needs a matched load.

Covered in the full lesson

  • Microphone amplifier
  • Frequency generator
  • Modulator
  • RF power amplifier
  • Feeder and antenna

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

What is modulation?
  1. Adding information to a radio frequency carrier
  2. Increasing the power of a signal
  3. Removing the carrier and one sideband from a signal
  4. Filtering noise from the audio
Answer: A. Modulation puts the audio or data onto the carrier.

The full lesson adds more

In the Foundation course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Next: Receivers and software defined radio

All revision notes · Free video lessons · The three exams