Revision notesFoundation · Section 4: Feeders and antennas

Feeders, connectors and matching: coax, baluns, SWR and the ATU

Coaxial and twin feeder, why feeders lose power, baluns, connectors, and how to check and correct the match between your antenna and transmitter.

Key points

Coax and twin feederCoax is unbalanced and screened, the most used. Twin feeder is balanced.
BalunFit one when feeding a balanced dipole with unbalanced coax.
Feeder lossLoss on transmit and receive; more with length and with frequency. Use low-loss cable at VHF and UHF.
ConnectorsBNC, N, SMA, PL259. Connect the braid correctly.
Match and SWRFeed point impedance should match feeder and transmitter. Mismatch reflects power; an SWR meter shows it.
High SWRFault in antenna or feeder, not the transmitter. Much above 2:1 can damage the transmitter. An ATU (AMU) corrects a mismatch.

Covered in the full lesson

  • Coax
  • Twin feeder
  • Balun
  • Feeder loss
  • Connectors
  • High SWR
  • ATU / AMU

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

Why is coaxial cable the most widely used feeder?
  1. Its screen keeps the signal inside
  2. It is balanced
  3. It has no loss
  4. It needs no connectors
Answer: A. Coax is screened (and unbalanced).

The full lesson adds more

In the Foundation course this lesson has a short video, drills, flashcards and a printable revision sheet, and the course ends with 5 full mock exams.

See the course

Next: Antennas: types, polarisation, patterns, gain and ERP

All revision notes · Free video lessons · The three exams